REFERENCE MANUAL E8-V5 - SIC-Venim s.r.o.

MOVE Z : machines equipped with a numerical Z axis + AutoSensing
Carries out a Z move with respect to the current Z position:
Z: Movement to be made: A positive value moves the head up to the workpiece
A negative value moves the head closer to its origin position.
Noteworthy points: If Z > 0, the marking head will take position at point XY of the first impact before descending
If Z < 0, the marking head will rise before making the moves in X and Y
AUTO Z : machines equipped with a numerical Z axis + AutoSensing
Positioning of the marking head on the workpiece:
D min : Minimum movement without encountering the workpiece
D max : : Maximum movement without encountering the workpiece
DZ : Stylus/workpiece marking distance
1st point: Sensing is carried out using the XY coordinate or at the first points to be marked?
Operation:
- Movement of the machine in Z over a stroke of D mini, then search for workpiece at low speed over a stroke
of (D max – D mini).
- If the workpiece is detected during the fast descent, or if no workpiece is detected during low speed
movement, the Z origin is resumed and the machine is declared defective.
EXT MOTEUR: machines equipped with extra motor piloted through RS232 port
Movement of an external axis:
Position : New coordinate of the axis
Functionning:
- Marking cycle starts: The controller runs the marking line until he founds the “movement” command.
- When process comes to this command, the axis moves to the coordinate (Crossed table doesn’t move)
- Cycle runs on next line.
NOTREFE8V5US – R01 33/51
Z
MOVE-Z EDITION
AUTO-SENSING EDITION
X X
D mini D maxi
DZ 1 st Last Z
Impact
EXTERNAL MOTOR EDITION
Position