Webwasher 6.0.1 Anti-Malware User's Guide - McAfee

Common
3–56
To add a text categorization rule to the list, use the area labeled:
• Add rule
Use the following items to configure a rule and add it to the list:
— [term 1] AND [term 2] AND NOT [term 3]
Make sure the radio button in this line is checked if you want to configure
a rule according to this method, which is one of two provided here.
This method uses Boolean logic to determine the placement of words
in an office document or e-mail message. It is enabled by default.
In the input fields, enter the words or word combinations you want to
filter, e. g. Bahamas, Maledives, work tosetuparulelikethefollowing:
Bahamas AND Maledives AND NOT work
— [term 1] more than [term 2] times per [term 3] words
Check the radio button in this line to configure a rule according to the
second method provided here.
It is based on counting how often a particular word or combination appears
in the text body of an office document or an e-mail message.
In the input fields, enter the word or word combination you want to filter,
e. g. money, 3, 10 to set up a rule like the following:
money more than 3 times per 10 words
— Select one or more categories to apply to the above rule
From the drop-down lists provided here select one or more categories.
The rule configured above will be applied within these categories.
— Create Rule
After setting up a text categorization rule, click on this button to add it
to the list.
This addition will be valid only under the policy you are currently configuring.
To add a rule to the list for all policies, mark the checkbox labeled Add
to all policies before clicking on the button.
The Text Categorization List is displayed at the bottom of this section.
To display only a particular number of list entries at a time, type this number
in the input field labeled Number of entries per page and enter it using the
Enter key of your keyboard.