Webwasher 6.0.1 Anti-Malware User's Guide - McAfee

Information Update
Introduction
Some parts of the information that is provided on the tabs of the Web interface
will change from time to time. In these cases, the information display is updated
automatically every three seconds by Webwasher.
So, e. g. you might have performed a manual update of the anti-malwar engine.
This means that the information provided in the Current Status and
Log File Content sections on the corresponding AV Engine tab will begin
to change continuously over a certain period of time until the update is completed.
These sections are then updated automatically every three seconds to reflect
the status of the update process.
Logout
To logout from a Webwasher session, click on the logout link, which is located
in middle position at the top of the Web interface area.
After logging out, the login page is displayed, where you can login again and
start a new session.
Main Feature Enabling
There are Webwasher settings that cannot only be modified if a corresponding
main feature is disabled. So, e. g. if you want to modify the settings of the
Phishing Filter sectionontheSettings tab under Anti-Spam > Message
Filters, you need to make sure the Message Filter feature itself is also enabled.
If you attempt to modify settings where the corresponding main feature is not
enabled, an alert is displayed to make you aware of this situation:
1–9