For Immediate Delivery call KMParts.com at - Moeller Electric Parts

10/94
Circuit-breakers, switch-disconnectors
NZM3 terminals
Circuit-breakers, switch-disconnectors
NZM3 terminals
10/95
Circuit-breakers, switch-disconnectors
up to 1600 A
Control circuit terminal
Moeller HPL0211-2004/2005
Moeller HPL0211-2004/2005
For use with Terminal capacity Terminal capacity Type suffix
Type of conductor Terminal capacity Copper strip Copper busbar
Article no.
width x
when ordered
thickness
with basic unit
mm
mm;B AWG/MCM mm
NZM3(-4)
PN3(-4), N3(-4)
Three- and
four-pole
Screw connection 1 x 0.75 – 4.0
2 x 0.75 – 2.5
1 x 18 – 12
2 x 18 – 14
Type
Article no.
for separate order
– – NZM3/4-XSTS
266797
Box terminal – – NZM-XSTK
266739
Notes
Type contains parts for two terminal locations located at top or
bottom for 3 or 4-pole circuit-breakers.
Included as standard with tunnel terminal
Degree of protection IP1X
NZM-XSTK cannot be combined with NZM3(-4)-XIPK
IP2X protection against contact with a finger.
Circuit-breakers, switch-disconnectors
up to 1600 A
Cover
NZM3
PN3, N3
NZM3-4
PN3-4, N3-4
3-pole – – – – – NZM3-XKSA
260045
4-pole – – – – – NZM3-4-XKSA
266801
Type contains parts for a terminal located at top or bottom for
3 or 4-pole circuit-breakers.
Insulation/protection against direct contact where cable lugs,
busbars or tunnel terminals are used.
Included in set with tunnel terminals
Degree of protection IP4X at front, side and rear, on the
connection side when using insulated conductor material to
IP1X.
IP2X protection against
contact with a finger
For box terminals
NZM3
PN3, N3
NZM3-4
PN3-4, N3-4
3-pole – – – – – NZM3-XIPK
266804
4-pole – – – – – NZM3-4-XIPK
266805
Type contains parts for a terminal located at top or bottom for
3 or 4-pole circuit-breakers.
Enhancement of the protection against direct contact to IP2X.
Protection when reaching into the cable connection area with
the connection of cables in the box terminal.
With 2 conductors minimum cross-section 95 mm 2 AWG 000.
Cannot be combined with NZM-XSTK control circuit terminal.
For cover as well as NZM3...(C)NA and N3...NA
NZM3
PN3, N3
NZM3-4
PN3-4, N3-4
Cable lug
not UL/CSA approved
When using cable lugs without NZM3(-4)-XKSA cover, they must be insulated.
185 mm 2 NZM3(-4)
PN3, N3(-4)
NZM4(-4)
N4(-4)
3-pole – – – – – NZM3-XIPA
266808
4-pole – – – – – NZM3-4-XIPA
266809
Three- and
four-pole
Copper conductors
Cu cable
1 x 185 1 x 350 – – NZM3-XKS185
260040
240 mm 2 1 x 240 – – – NZM3-XKS240
260041
Type contains parts for a terminal located at top or bottom for
3 or 4-pole circuit-breakers.
Only in conjunction with NZM3(-4)-XKSA cover.
Enhancement of the protection against direct contact to IP2X.
When mounting NZM3-..-(C)NA or N3...-NA the following
applies:
With 2 conductors minimum cross-section 95 mm 2 AWG 000.
The type contains a cable lug for 3 or 4-pole switch.
Special cable lug, narrow style
For Immediate Delivery call KMParts.com at (866) 595-9616