Korg Microkorg Owner's Manual - zZounds.com
Korg Microkorg Owner's Manual - zZounds.com
Korg Microkorg Owner's Manual - zZounds.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
20. ARPEG. B — SYNTH/VOCODER<br />
Here you can make additional arpeggio-related settings. "LAST STEP" (knob 4 ) sets the number of steps in the arpeggio. "LATCH" (knob 1 )<br />
specifies how the arpeggiator will operate when you release the keyboard, "SWING" (knob 2 ) adjusts the sense of swing, and "KEY SYNC"<br />
(knob 3 ) specifies how the arpeggiator will be synchronized to the keyboard. In addition, "TARGET TIMBRE" (knob 5 ) specifies which<br />
timbre(s) of a Layer synth program will be sounded by the arpeggiator.<br />
LATCH<br />
[OFF, ON]<br />
Specifies how the arpeggiator will<br />
operate when you take your hand<br />
off of the keyboard.<br />
OFF ( ):<br />
The arpeggiator will stop playing<br />
when you take your hand off of the<br />
keyboard.<br />
ON ( ):<br />
The arpeggiator will continue playing<br />
even if you take your hand off<br />
of the keyboard.<br />
SWING [-100...100]<br />
Specifies the percentage (%) by<br />
which even-numbered notes of the<br />
arpeggio will be shifted in timing<br />
relative to the first note.<br />
(➝Figure 20-1)<br />
KEY SYNC<br />
[OFF, ON]<br />
Specifies whether the arpeggiator<br />
will be synchronized to the keyboard.<br />
If this is ON, the arpeggiator will<br />
always start from the beginning of<br />
the arpeggio pattern when you play<br />
the keyboard. If you are performing<br />
together with other instruments,<br />
you can use this function to<br />
ensure that the arpeggio pattern is<br />
aligned with the beginning of the<br />
measure.<br />
OFF ( ):<br />
Sync off (not synchronized).<br />
ON ( ):<br />
Sync on (synchronized).<br />
LAST STEP [1...8]<br />
Specifies the number of valid steps<br />
(maximum number of steps) for the<br />
step arpeggiator.<br />
TARGET TIMBRE<br />
[Both, Timbre 1, Timbre 2]<br />
Selects the timbre(s) that will be<br />
sounded by the arpeggiator. This<br />
can be set only for a Layer program.<br />
Both ( ):<br />
Both timbres will be sounded by the<br />
arpeggiator.<br />
Timbre 1 ( ):<br />
Only timbre 1 will be sounded by<br />
the arpeggiator.<br />
Timbre 2 ( ):<br />
Only timbre 2 will be sounded by<br />
the arpeggiator.<br />
Figure 20-1<br />
When Resolution =1/8<br />
1 2 3 4 5 6 7 8 9<br />
Swing –50 –25 +25 +50<br />
45