Linear Way L

Rail cover platePS
U.S. PATENT NO. 5,622,433
Rail cover plate
After mounting the track rail, the top surface of
track rail is covered with a U-shaped thin
stainless steel plate for further improvement in
sealing performance. The rail cover plate is
delivered as assembled on the track rail.
Standard end seals must be replaced with the
special end seals.
When mounting the cover plate, refer to the
attached instruction manual for rail cover plate.
Capillary plateQ
U.S. PATENT NO. 6,190,046
NO. 6,176,617
NO. 6,082,899
NO. 5,967,667
Track rail with stopper pinsS
Stopper pin Stopper pin
Capillary plate
Capillary plate
To prevent the slide unit of Linear Way L from
slipping off, a stopper pin is provided at both
ends of the track rail. For related dimensions,
see the description of Linear Way L.
The capillary plate is assembled inside the end
seal of the slide unit. It is impregnated with
lubricant so that re-lubrication interval can be
made longer. For the total length of the slide
unit with capillary plate, see the description of
each series.
Seal for special environment RE
The standard end seals and under seals are
changed to seals for special environment that
can be used at high temperature.
Butt-jointing interchangeable track rail (for interchangeable specification) T
A special interchangeable track rail of which both ends are finished for butt-jointing is provided.
Use the track rails having the same interchangeable code for butt-jointing. For the non-interchangeable
specification, indicate "butt-jointing track rail (/A)".
With under sealsU
U.S. PATENT NO. 5,464,288
NO. 5,356,223
NO. 5,324,116
NO. 5,306,089
NO. 5,209,575
H1
To prevent foreign substances intruding from
the lower side of Linear Way, seals are provided
on the bottom faces of slide unit. For size H1,
see the description of each series.
Under seal
Under seal
1N=0.102kgf=0.2248lbs.
1mm=0.03937inch
89