TS-9720EN Series Progressive Scan Shutter Cameras - JAI Pulnix
TS-9720EN Series Progressive Scan Shutter Cameras - JAI Pulnix
TS-9720EN Series Progressive Scan Shutter Cameras - JAI Pulnix
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Page 17<br />
Tutorial<br />
You can connect up to two light sensors. If two IP addresses and port numbers are identical, then the EN<br />
camera tries to connect only a single light sensor.<br />
Set the ADR Control register from “Manual” to “ADR Control (Using the Light Sensor).” This will<br />
activate the connection to the light sensor. If the connection is successful, you should see a live data<br />
change in the ADR Debug side A/B registers. Also, you should see what camera parameters ADR<br />
decides to set. In the above example, ADR sets to exposure time 4H (Dial 4 = 4H), Gain=255(max),<br />
Vtop=0, and Vbot=0. If there is a connection error, then these register values will all remain zero.<br />
Also, check the “Error Status” register. If there is a connection error, LS1_ERR or LS2_ERR is set. If a<br />
light sensor is not required for your application, set the “Camera ADR Control” register to “Manual.”<br />
3.3.2 Flash Nighttime Light Control<br />
The strobe and continuous nighttime light can be manually turned on and off. Set “Flash Auto/Manual”<br />
and “Night light Control” registers to Manual OFF or ON.<br />
<strong>TS</strong>-<strong>9720EN</strong> <strong>Series</strong> <strong>Progressive</strong> <strong>Scan</strong> <strong>Shutter</strong> <strong>Cameras</strong>
Change language