Users Manual WP 900 UHF.pdf - Jotron
Users Manual WP 900 UHF.pdf - Jotron
Users Manual WP 900 UHF.pdf - Jotron
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Handook page<br />
12/128<br />
Installation Guide<br />
T942C- and T942C/2 Central Unit<br />
TD 91684GB<br />
1.3.5 Addressing<br />
Assign the T942C an address on the C-bus by setting address switch SW01 hexadecimally.<br />
(See the document System Installation, under Addressing).<br />
OFF<br />
ON<br />
1<br />
SW01<br />
8<br />
Figure 11. Addressing on T942C<br />
• If no additional units are connected to the C-bus: Assign the Central Unit address 00.<br />
• If additional units are connected to the C-bus, the address must not be the same as any<br />
other unit on the C-bus. Note that units on the C-bus must always be assigned<br />
addresses in ascending order starting with 00.<br />
1.3.6 Jumpering for Use as Common Line Interface<br />
To use T942C as a Common Line Interface (CEI) in the 5000 system, close the jumpers and<br />
remove the resistors listed below:<br />
For Data Link Connection:<br />
Jumpers:<br />
Resistors<br />
S04, S06, S07, S18 and S19<br />
R104 and R105<br />
For Charging Rack Scanning:<br />
Jumpers:<br />
Resistors<br />
S05, S08, and S09<br />
R060, R086 and R088<br />
2003-01-08 / Rev.C<br />
10