2635 manual - BK Precision
2635 manual - BK Precision
2635 manual - BK Precision
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
(23) PROBE POWER:<br />
PROBE POWER is used solely to supply power for the near field<br />
probes HZ530. The required special power cable is supplied with<br />
the probe set.<br />
(24) VOL.: To regulate the volume for the head set.<br />
(25) PHONE:<br />
Connector for headset. The head set should be equipped with a<br />
3.5mm stereo phone connector and have >8 Ohm of impedance.<br />
(26) ATTN.<br />
The TG output attenuator has 5 positions,which can be<br />
chosen via the UP/DOWN-buttons. The output attenuator is used<br />
for reducing the output level of the Tracking Generator.<br />
(27) LEVEL<br />
With the LEVEL knob the output level of the Tracking generator<br />
can be varied in steps of 0.2 dB. The range for level settings is 11<br />
dB. The output level is shown in the readout, also dependent on<br />
the attenuator setting.<br />
Attention:<br />
If Tracking Generator is not activated, the output level can<br />
be still varied, this is visible in the readout. For having<br />
this signal appliued to the output, the Tracking generator<br />
must be activated. This is a security measure to prevent<br />
damages to sensitive loads.<br />
26 Subject to change without notice
Change language