2635 manual - BK Precision

More documents

Recommendations

Info

Print Print preview and start of printing. Printer Setup Set-up for the printer being attached to the PC Database Selection Selection of the database to be used. 44 Subject to change without notice
Exit Exit program. Pulldown Menu 2: (Command Mode Normal) Settings Configuration Set-up of the serial interface, set COM port and transfer rate; possibility of automatic rate identification. Measurement Opens window for instrument set-up and a waveform graph to display the actual measurement data. Display Mode Two areas are defined: Spectrum Analyzer and graphic display on the PC’s screen. Tracking Window for controlling the Tracking Generator. Pulldown Menu 3: Mode Normal EMC Subject to change without notice Remote operation of the Spectrum Analyzer via PC. Acquisition, analysis and storage of data on the PC. Extended operating procedures for measuring emitted radiation with an antenna including correction for antenna gain, damping characteristics of cables and amplifiers, etc.). 45
Page 1 and 2: ® INSTRUCTION MANUAL MODELS 2635 1
Page 3 and 4: Table of contents Software Pulldown
Page 5 and 6: Subject to change without notice 5
Page 7 and 8: frequency characteristics of 4-term
Page 9 and 10: Special Functions Average SAVE/RECA
Page 11 and 12: General Information Symbols Tilt ha
Page 13 and 14: Operating Conditions The instrument
Page 15 and 16: The fuseholder can be released by p
Page 17 and 18: Control Elements When measuring via
Page 19 and 20: Remark: Functions AVERAGE and MAX.H
Page 21 and 22: otherwise not be visible due to the
Page 23 and 24: accordingly when moving towards the
Page 25 and 26: (UNCAL display). In this case, SPAN
Page 27 and 28: Operation - first steps (28) Tracki
Page 29 and 30: Obtaining values: For a numerical v
Page 31 and 32: The swept-tuned analyzers are usual
Page 33 and 34: Resolution Before the frequency of
Page 35 and 36: Spectrum Analyzer Sensitivity Speci
Page 37 and 38: tuning since both are effectively t
Page 39 and 40: #dm0 (E) = Detect mode off #dm1 (E)
Page 41 and 42: Manual Software SW5012 Subject to c
Page 43: Edit Delete New, Copy, Edit, Delete
Page 47 and 48: In the “Settings” window ten di
Page 49 and 50: In the next step - for example - th
Page 51 and 52: Definition of limit lines used for
Page 53 and 54: The next step to be defined is the
Page 55 and 56: Now follow the steps as indicated o

2635 manual - BK Precision

Create successful ePaper yourself

Delete template?

Save as template?