Novell eDirectory 8.8 Troubleshooting Guide - NetIQ

14Clone DIB Issues
• Section 14.1, “Clone DIB Fails With -601 and -603 Errors,” on page 73
• Section 14.2, “Clone DIB Can Fail Immediately After Offline Bulkload,” on page 73
• Section 14.3, “Issue in Cloning with Enabled Encrypted Replication Feature,” on page 73
14.1 Clone DIB Fails With -601 and -603 Errors
When encrypted attributes and encrypted replication is enabled at the tree level, clone DIB fails with
the following errors:
• Clone DIB on target server fails with the -601 error while configuring SAS
• After Clone DIB, the newly created clone object fails with the -603 error
To work around these issues, disable encrypted attributes and encrypted replication.
14.2 Clone DIB Can Fail Immediately After Offline
Bulkload
If you try taking the clone of a server immediately after an offline bulkload, it might result in a
failure, if the bulkload has been done with the disable indices option.
However, this is not an issue if the dibclone is initiated a few hours after the bulkload completion.
14.3 Issue in Cloning with Enabled Encrypted
Replication Feature
While cloning with the Encrypted Replication feature enabled on the source server, modify the ER
policy to temporarily exclude the cloned server. This can be changed after the configuration of the
cloned server is complete.
14
novdocx (en) 22 June 2009
Clone DIB Issues
73