SX25 Series Process Controller - Spirax Sarco

More documents

Recommendations

Info

When the controller is powered up for the first time, the display shows the following message. Alarm 2 type and function N Not active 0 Sensor break alarm/Loop Break Alarm 1 <strong>Process</strong> active high 2 active low 3 Deviation active high 4 active low 5 Band active out 6 active in 7 This shows that the controller has not been configured. Input the first code ILMN , using the up and down arrow keys, then press the enter key. The lower display will show Con2 . Now input code O for alarm 3, then press enter. The controller will remain in stand-by until the configuration code is set correctly (see section 5.6 page 36). CON2 Alarm 3 type and function O Disabled 0 Sensor break alarm/Loop Break Alarm 1 <strong>Process</strong> active high 2 active low 3 Deviation active high 4 active low 5 Band active out 6 active in 7 For alarm type and function see page 30. 20 IM-P323-25 CH Issue 3
5.1 Keys and display overview 5 Operations 5.1.1 Key functions and display in operator mode 5.1.2 Key functions and display in programming mode IM-P323-25 CH Issue 3 21
Page 1 and 2: 3231450/3 IM-P323-25 CH Issue 3 SX2
Page 3 and 4: General Index 1. Safety Information
Page 5 and 6: viii) A disconnecting device (switc
Page 7 and 8: 2.2 Dimensional details 2.3 Panel c
Page 9 and 10: 2.5 Panel mounting 2.5.1 Insert the
Page 11 and 12: 3.2 Precautions and advised conduct
Page 13 and 14: 3.3.2 PV control unit D For mA, mV
Page 15 and 16: SX25 mA Output combination 3.3.5 -
Page 17 and 18: 3.3.5 - L Double Action Logic/ Rela
Page 19: 4.1 Configuration coding The config
Page 23 and 24: 5.3 Parameter setting 5.3.1 Numeric
Page 25 and 26: 5.3.3 Keypad lock To lock/unlock th
Page 27 and 28: P 33 PpAss Password entry only if C
Page 29 and 30: pass Password entry only if Code va
Page 31 and 32: OC Overshoot control (Automatically
Page 33 and 34: Second group tf ¡l Input filter ti
Page 35 and 36: Analogue control output OP4 r£tr A
Page 37 and 38: Password entry only if Cod£ value
Page 39 and 40: 6 Commissioning Examples When the c
Page 41 and 42: First group parameters Press the sc
Page 43 and 44: 6.2 Example of temperature control
Page 45 and 46: Second group parameters The display
Page 47 and 48: The self-learning Adaptive Tuning i
Page 49 and 50: Features (at 25°C environmental te
Page 51: Features (at 25°C environmental te

SX25 Series Process Controller - Spirax Sarco

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?