SX25 Series Process Controller - Spirax Sarco
SX25 Series Process Controller - Spirax Sarco
SX25 Series Process Controller - Spirax Sarco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5.6 Configuration menu<br />
The configuration of the controller is<br />
specified through a 4 digit code that<br />
defines the type of input, of control<br />
output and of the alarms.<br />
(section 4.1 page 19).<br />
Press or to display<br />
the next parameter or the next<br />
code and change its value.<br />
The new value entered is stored<br />
into the controller when the next<br />
parameter is selected by<br />
pressing .<br />
Operator<br />
mode<br />
Auto / Man<br />
selection<br />
(see page 25)<br />
Pressing the will display<br />
the next group of parameters.<br />
Note:<br />
You must remember<br />
the password code.<br />
If the code is changed<br />
from 33, and the operator<br />
forgets the code,<br />
he will be locked out<br />
of the controller.<br />
Control output<br />
selection<br />
(only if installed)<br />
non£ Not used<br />
NU Heat NU C Cool<br />
Change password [2]<br />
To change the password<br />
from 0...9999<br />
33 default from factory<br />
36<br />
IM-P323-25 CH Issue 3