SX25 Series Process Controller - Spirax Sarco
SX25 Series Process Controller - Spirax Sarco
SX25 Series Process Controller - Spirax Sarco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.4 Parameter menu<br />
Note:<br />
[1] This will not be displayed if the<br />
controller has been configured<br />
with alarm 2 not active or if<br />
sensor break type selected.<br />
Digit N/M of the configuration<br />
code is assigned to 0 or 1.<br />
27.4.8<br />
275.0<br />
Operator<br />
mode<br />
Auto/Man<br />
selection<br />
(see page 25)<br />
A.<br />
U<br />
8n<br />
The parameter setting procedure<br />
has a timeout. If no key is pressed<br />
for 30 seconds, the controller<br />
automatically switches back to the<br />
operator mode.<br />
After having selected the parameter<br />
or the code, press and to<br />
display or modify the value (see<br />
page 24) The value is entered when<br />
the next parameter is selected, by<br />
pressing the key.<br />
Pressing the key, the next<br />
group of parameters will be<br />
displayed.<br />
[2] Before Adpt is switched off,<br />
note down the calculated<br />
values. Pb., t.¡, t.d. are not<br />
automatically stored.<br />
0<br />
A35.Pp<br />
5.0<br />
p.b.<br />
5.0<br />
t.i.<br />
AL3 alarm<br />
threshold [1]<br />
(see page 30)<br />
Proportional band<br />
(PID algorithm only)<br />
0.5...999.9% of span<br />
Integral time<br />
(PID algorithm only)<br />
0ff / 0.1...100.0 min<br />
1.00<br />
t.d.<br />
20<br />
t.c.<br />
1.00<br />
O.C.<br />
Deriv<br />
(PID<br />
Off/0<br />
Cycle<br />
(time<br />
algori<br />
Overs<br />
(PID<br />
0.01..<br />
26<br />
IM-P323-25 CH Issue 3
Change language