SPICE-Simulation using LTspice IV

Solution for Task 1:
First right click on the symbol of the
voltage source to open the property
menu. Then fill the PWL-list with
the informations about the
additional points and value pairs
(use the button “Additional PWL
Points”):
0 0
1m 0
1,000001m 1000000
1,001001m 1000000
1,001002m 0
When simulating input and output voltage you get this screen where only the Dirac impulse with its amplitude of 1
Megavolt can be seen:
Use the zoom function for other details, because the system’s response has only an amplitude of 10KV. So
change the scaling of the two axis to see the response curve -- and afterward have a look at the solution on the
following page.
24