SPICE-Simulation using LTspice IV

More documents

Recommendations

Info

Note: To return to the transient simulation, please replace the point in the .op simulation command by a semicolon. Also replace the semicolon in the ;tran command by a point. But the fastest way is using the path „Simulation / Edit Simulation Command / Transient”. There click OK and this operation will be automatically done by the software. 58
9.2.5. Frequency Domain Simulation: AC Sweep No problem: Open the property menu of the voltage source V1, enter „1“ for the AC-amplitude, „0“ for the AC-phase and a new simulation command for an AC-sweep from 1Hz to 200MHz with 101 points per decade: 59
Page 1 and 2:
SPICE-Simulation using LTspice IV T
Page 3 and 4:
8. Project 4: U-I-Curves of Parts 4
Page 5 and 6:
1. Introduction Modern electronics
Page 7 and 8: 3.2. Presentation of Simulation Res
Page 9 and 10: 3.4. Changing Curve Colours A very
Page 11 and 12: Task: Make the voltage curve visibl
Page 13 and 14: Step 2: Enter the new border values
Page 15 and 16: 3.7. Differential Measurements Ever
Page 17 and 18: 3.9. Changing Part Values Now we wa
Page 19 and 20: 4.2. Changing Part Values This is d
Page 21 and 22: Now start the simulation, click on
Page 23 and 24: 4.3.3. The Impulse Response Fourier
Page 25 and 26: This is the correct presentation: -
Page 27 and 28: 4.4.2. Square Wave (f = 1691 Hz) St
Page 29 and 30: 4.5. Frequency Domain Simulation: A
Page 31 and 32: 5. FFT (= Fast Fourier Transformati
Page 33 and 34: Select Input Voltage V(n001) by a m
Page 35 and 36: 6.2. Important: creating SPICE Mode
Page 37 and 38: 6.2.2. Creation of the Symbol for a
Page 39 and 40: For an ideal transformer you can re
Page 41 and 42: Step 5: self-explainig…. 41
Page 43 and 44: -----------------------------------
Page 45 and 46: When simulating for 200ms, you will
Page 47 and 48: 8. Project 4: V-I-Curves of Parts 8
Page 49 and 50: 8.3. NPN Transistor In the „examp
Page 51 and 52: 8.4. N-Channel Junction FET First w
Page 53 and 54: In the simulation we would like to
Page 55 and 56: 9.2. Two Stage Broadband Amplifier
Page 57: 9.2.4. DC Bias If you want to know
Page 61 and 62: You will see this result and that a
Page 63 and 64: Using the cursor you will find the
Page 65 and 66: Let us now draw the complete circui
Page 67 and 68: 10.3. Use of Labels In general OP A
Page 69 and 70: 11. Project 7: DC-DC Converters Fir
Page 71 and 72: 11.2. The Step Up Converter The sch
Page 73 and 74: If you want: vary the gate voltage,
Page 75 and 76: 11.4. The Step Down Converter In th
show all

SPICE-Simulation using LTspice IV

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?