SPICE-Simulation using LTspice IV

9.1.2. Frequency Domain Simulation (“AC Sweep”)
Step 1:
Change the properties of voltage source V1 to “AC-Sweep”
by entering the values “1” for the AC Amplitude and “0” for
the AC Phase.
Make the information visible on the schematic.
Step 2:
Open „Simulate“ and „Edit Simulation Command“ to get
this menu. In „AC Analysis“ please enter the values for a
decade sweep with 101 points per decade from 1 Hz to
200MHz.
So the simulation result should look like this:
54