FS2004 Users Manual - FuturePlus Systems

More documents

Recommendations

Info

After clicking “next” you must browse for the fast binary data file you want to import. Once you have located the file and clicked start import, the data should appear in the listing. After the data has been imported you must load the protocol decoder before you will see any decoding. To load the decoder select Tools from the menu bar, when the drop down menu appears select Inverse Assembler, then choose the name of the decoder for your particular product. The figure below is a general picture; please choose the appropriate decoder for the trace you are working with. After the decoder has loaded, select Preferences if required, from the overview screen and set the preferences to their correct value in order to decode the trace properly. This is a general requirement, some decoders do not have preferences, if this is the case then no preference setting is necessary. 18
The Format Menu The <strong>FS2004</strong> diskette sets up the format menu as shown in the following table (1655x, 167x,16510 and 166x, 1680/90). This format is the same for both Timing and State Analysis. Label Clk Inputs Pod 4 Pod 3 Pod 2 Pod 1 STAT 9-0 14-0 ADDR 15-0 15-0 ADDR_B USER2_1 16 16 INTD_A 14-11 RESET 10 C/B3_0 9-6 DATA 15-0 DEVSEL 5 STOP 4 LOCK 3 PERR 2 SERR 1 PAR 0 SD/SB0 5-6 ACK/RQ 1-0 IRDY 7 19
Page 1 and 2: FuturePlus Systems Corporation LOCA
Page 3 and 4: 1680/90/900 Licensing 15 Loading 16
Page 5 and 6: How to reach us For Technical Suppo
Page 7 and 8: Introduction How to Use This Manual
Page 9 and 10: Connecting the Jumpers There are th
Page 11 and 12: For 16540/541 Logic Analyzers Logic
Page 13 and 14: SW1 CLKRUN# R1 AD29 R2 AD26 R3 AD24
Page 15 and 16: FS2004 protocol decoder by placing
Page 17: offline analysis feature on a PC yo
Page 21 and 22: STAT Variable PC Card Cardbus Bus S
Page 23 and 24: Symbol TRDY# FRAME# IRDY# C/BE(3:0)
Page 25 and 26: Acquiring Data Touch RUN and, as so
Page 27 and 28: 16700 Display 27
Page 29 and 30: Error Messages The following error
Page 31 and 32: 16700 Invasm Filter Options Filteri
Page 33 and 34: Setting up the 1680/90/900 for PC M
Page 35 and 36: The following listing shows the PC
Page 37 and 38: Interrupt Vector Table Address bits
Page 39 and 40: Address bits 23-0 000008H 000004H 0
Page 41 and 42: 00C8H Address bits 23-0 SLAVE DMA C
Page 43 and 44: Timing Analysis Installation Quick
Page 45 and 46: General Information Characteristics
Page 47 and 48: Signal Connections Test Point pinou
Page 49 and 50: Preprocessor Cable Header and Pin n
Page 51 and 52: Preprocessor Cable Header and Pin n
Page 53: 53 CLKRUN# AD29 AD26 AD24 AD22 AD20

FS2004 Users Manual - FuturePlus Systems

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?