Operating and installation instructions Oven H 5141 BP, H 5241 BP

Cleaning and care
Pyrolytic cleaning of the oven
interior
Before starting a pyrolytic cleaning
process please note the following:
Remove any coarse soiling from the
oven before you start.
Clean the inside of the door (glass).
There is a fibre-glass door seal
around the oven cavity.
This seal is particularly sensitive and
should not be cleaned unless
absolutely necessary. Rubbing can
damage it.
Remove all accessories as well as
the runners and any extra
accessories such as Flexi-Clip
runners from the oven interior before
starting the pyrolytic cleaning
process. The high temperatures
needed for pyrolysis will damage the
accessories.
During the pyrolytic process the oven is
heated to over 400 °C. Any residual
soiling is broken down and reduced to
ash by the high temperatures.
For safety reasons the oven door is
automatically locked at the beginning of
the pyrolytic programme.
Depending on soiling levels you can
choose between three cleaning
programmes:
– PY I (duration of approx. 2 hours)
– PY 2 (duration of approx.
2 hours 15 mins)
– PY 3 (duration of approx.
2 hours 30 mins)
The door cannot be opened until this
duration has been completed.
You can delay the start of the pyrolytic
process for example, to take advantage
of cheaper night electricity tarifs.
The oven door gets much hotter
during pyrolytic operation than
during normal use.
Make sure children cannot touch the
oven whilst a pyrolytic programme is
running. Danger of burning.
56