Operating instructions - EWM Hightec Welding GmbH
Operating instructions - EWM Hightec Welding GmbH
Operating instructions - EWM Hightec Welding GmbH
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Maintenance and testing<br />
General<br />
7 Maintenance and testing<br />
NOTE<br />
The maintenance, cleaning and testing work described below must be conducted<br />
correctly and on an annual basis in order qualify for claims under the <strong>EWM</strong> warranty.<br />
7.1 General<br />
When used in the specified environmental conditions and under normal operating conditions, this<br />
machine is largely maintenance-free and requires a minimum of care.<br />
There are some points, which should be observed, to guarantee fault-free operation of your welding<br />
machine. Among these are regular cleaning and checking as described below, depending on the pollution<br />
level of the environment and the length of time the unit is in use.<br />
7.2 Cleaning<br />
NOTE<br />
The welding machine may only be cleaned, tested and repairied by competent, capable<br />
personsl.<br />
A capable person is one who, because of his training, knowledge and experience, is able<br />
to recognise the dangers that can occur while testing welding power sources as well as<br />
possible subsequent damage and who is able to implement the required safety<br />
procedures.<br />
In the event of failure to comply with any one of the following tests, the machine must not<br />
be operated again until it has been repaired and a new test has been carried out!<br />
DANGER<br />
Risk of injury from electric shock!<br />
Cleaning machines that are not disconnected from the mains can lead to serious injuries!<br />
• Disconnect the machine completely from the mains.<br />
• Remove the mains plug!<br />
• Wait for 2 minutes until the capacitors have discharged.<br />
The individual components should be handled as follows:<br />
Power source: Depending on the amount of dust, blow out using oil- and moisture-free compressed air.<br />
Electronics: Do not blast electronic components or circuit boards with compressed air but clean them<br />
with a vacuum cleaner instead.<br />
Coolant: Check for impurities and replace if necessary.<br />
NOTE<br />
Mixing coolants with other liquids or the use of other coolants voids our manufacturer's<br />
guarantee.<br />
66 Item No.: 099-000097-<strong>EWM</strong>01