G61R Digital Surround Controller Installation Guide - Meridian

To connect the G61R to Meridian DSP loudspeakers (daisy chain)
G61R Digital Surround Controller
SPEAKERLINK
OUTPUTS
DSP Loudspeaker – Main Left (Master)
SPEAKERLINK
INPUT OUTPUT
SPEAKERLINK LEAD
DSP Loudspeaker – Centre (Slave)
SPEAKERLINK
INPUT OUTPUT
SPEAKERLINK LEAD
DSP Loudspeaker – Rear Left (Slave)
SPEAKERLINK
INPUT OUTPUT
This is an alternative to the “home run” wiring configuration
shown in the next section.
The G61R automatically assumes that the main left speaker is the
master, unless it is analogue, in which case the DSP centre, left
side, or left rear is used in order of priority (unless explicitly set
differently in the Meridian Configuration program).
• Connect the appropriate SpeakerLink output on the lower row
of the G61R to the master digital speaker (typically the main left
speaker), using a Meridian SpeakerLink lead.
SPEAKERLINK LEAD
DSP Loudspeaker – Main Right (Slave)
SPEAKERLINK
INPUT OUTPUT
DSP Subwoofer – Sub (Slave)
SPEAKERLINK
INPUT OUTPUT
DSP Loudspeaker – Rear Right (Slave)
SPEAKERLINK
INPUT OUTPUT
• Connect the appropriate SpeakerLink outputs on the G61R to
one of each of the remaining pairs of speakers, using a Meridian
SpeakerLink lead.
• Link each pair of speakers together with a Meridian SpeakerLink
lead, out of the first speaker and into the second speaker, as
shown in the diagram.
The speakers should then be configured appropriately as master
and slaves, and Left, Right, Centre, Surround; see Meridian DSP
Loudspeaker User Guide for more details.
I n s t a l l i n g t h e
d i g i t a l s u r r o u n d
c o n t r o l l e r