Operators Manual

9. JOB BUILD
This function allows up to five sets of originals to be scanned and stored separately and then to be
copied and output all at once.
1
1
Press
2
Press
3
Press
4
The
5
Select
the key on the control panel while in the
initial screen for copying. The "EDIT MENU" screen
appears.
the key to display the "JOB BUILD."
Then press the key.
the key to display the "ON." Then press
the key.
"JOB BUILD: ON" screen appears. Press the
key to return to the initial screen for copying.
the desired paper cassette, image density,
reproduction ratio and copy quantity.
To select the paper cassette, press the key, select AMS
and then select the desired paper cassette.
6
Place the original on the glass or feed tray and press
the key.
7
After
Note
the original is scanned, the screen on the right
appears.
• When scanning the next original without changing any
settings, place it on the glass or feed tray and select "Scan
next page." Then press the key.
• In scanning the next original, if the scan density and Edge
Erase settings are changed, select "Change current
settings" to change the settings. Then press the key.
• When all originals have been scanned, select "End job build"
to start copying automatically. Then press the key.
READY 1
ANNOTATION :OFF
EDITING :OFF
JOB BUILD :OFF
JOB BUILD 1
OFF
ON
READY 1
ANNOTATION :OFF
EDITING :OFF
JOB BUILD :ON
Scanning in memory 1
Scanning Page
:XXX
JOB BUILD 1
Scan next page
End job build
Change current setting
2
3
4
5
6
7
8
9
10
11
12
4-25