KM1301SAH-E Service Manual - Hoshizaki
KM1301SAH-E Service Manual - Hoshizaki
KM1301SAH-E Service Manual - Hoshizaki
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1. Control Board Layout<br />
"G" Control Board<br />
• Bin Control Switch<br />
Closed LED (green)<br />
(on continuously<br />
in thermostatic bin<br />
control application)<br />
• Bin Control Switch<br />
Open LED (yellow)<br />
(mechanical bin control<br />
application only)<br />
• Part Number<br />
• Alarm Buzzer<br />
• Power LED (red)<br />
(lights when power<br />
is supplied to the<br />
control board)<br />
• Relay LEDs<br />
(4) (indicate<br />
which relays are<br />
energized as listed<br />
below)<br />
• LED 2 (X2 Relay)<br />
Hot Gas Valve (HGV)<br />
Fan Motor (FM)<br />
(FM off when LED on)<br />
• LED 3 (X3 Relay)<br />
Pump Motor (PM)<br />
(on at pump-out,<br />
harvest (if applicable))<br />
• LED 4 (X4 Relay)<br />
Inlet Water Valve (WV)<br />
• LED 1 (X1 Relay)<br />
Compressor (Comp),<br />
Fan Motor-Remote<br />
(FMR)<br />
• "ALARM RESET" Button<br />
• S4 Dip Switch<br />
• "OUTPUT TEST" Button<br />
(used to test relays on control board)<br />
• WHITE K3 Connector<br />
Harvest Control<br />
(thermistor)<br />
• RED K4 Connector<br />
K4 Jumper (4A4883G01)<br />
for Thermostatic Bin<br />
Control Application<br />
(KM-1301SAH-E) or<br />
Mechanical Bin Control<br />
(KM-1301SWH-E,<br />
KM‐1301SRH-E)<br />
• S5 Dip Switch<br />
• BLACK K5 Connector<br />
Float Switch<br />
• Label<br />
(control board revision<br />
level indicated on label<br />
on side of relay)<br />
• K1 Ten-Pin Connector<br />
Pins #1 through #10<br />
#1, 9 Magnetic Contactor<br />
#2 Hot Gas Valve (HGV)<br />
#3 Liquid Line Valve (LLV),<br />
Fan Motor (FM)<br />
#4 Pump Motor (icemaking)<br />
#5 Pump Motor (pump-out,<br />
harvest (if applicable))<br />
#6 Inlet Water Valve (WV)<br />
#7, 10 Component Power<br />
Supply<br />
#8 Open<br />
• K2 Connector<br />
Transformer<br />
"G" Control Board<br />
Part Number 2A3792-01<br />
19