Zoll 1400 Operators Manual

More documents

Recommendations

Info

Chanter 4 NOTES If the defibrillator is not discharged within 60 seconds of reaching the selected energy level, the PD <strong>1400</strong> automatically dumps the stored energy internally. During the ten seconds prior to this internal dump, the charge ready tone will beep intermittently. The charge ready tone will then stop, the charge indicator light go off, and the monitor message will change to “DEFIB XXXJ SEL.“. PADDLE CLEANING Paddle plates and handles must be thoroughly cleaned after each use. See chapter 8 for correct cleaning procedure. WIII
Defibrillator “ELECTRODES” is selected as the ECG source when the instrument is turned to MONITOR ON or DEFIB ON. You may then select any of the ECG leads - I, II, III or ELECTRODES. (ECG cable and electrodes must already be attached to the patient to use lead I, II, or III.) CHANGE DEFIB ENERGY LEVEL To change the defib energy level from the pre-selected level (2OOJ), use the up-down arrow buttons located on the front panel. The selected energy level is displayed digitally as “DEFIB XXX J SEL.” on the monitor. Emergency Defibrillation Procedure Emergency Defibrillation Procedure with Multi-Function Electrodes WARNING Before proceeding, CAREFULLY read the following: Emergency defibrillation should be attempted by appropriately trained, skilled personnel that are familiar with equipment operation. Training appropriateness, such as ACLS (Advanced Cardiac Life Support) certification, should be the determination of the prescribing physician. Do not touch the bed, patient, or any equipment connected to the patient during defibrillation. All persons in attendance of the patient must be warned to “STAND CLEAR” prior to defibrillator discharge. SELECT DEFIB ON Turn the selector switch to DEFIB ON. This turns the power on and automatically sets the defibrillator energy level to 200 joules.
Page 2 and 3: PREFACE About This Manual.. .......
Page 4 and 5: Table of Contents CHAPTER 9 Trouble
Page 6 and 7: This manual provides information ne
Page 8 and 9: General Information SAFETY The ZOLL
Page 10 and 11: 2. As a standby when standstill or
Page 12 and 13: Defibrillator Complications Inappro
Page 14 and 15: U.S.A. customers SPECIFICATIONS GEN
Page 16 and 17: Patient Connection input Protection
Page 18 and 19: ACCESSORIES (STANDARD) W Standard A
Page 20 and 21: � � El CHARGE Press the charge
Page 22 and 23: � � H � � Controls and Indi
Page 24 and 25: SUMMARY REPORT Summary Report first
Page 26 and 27: PRINTING A To retrieve recorded eve
Page 28 and 29: INTRODUCTION MULTI-FUNCTION ELECTRO
Page 30 and 31: “ELECTRODES OFF” If the operato
Page 32 and 33: Chapter 4 WARNING To avoid risk of
Page 36 and 37: Chapter 4 APPLY ELECTRODES TO CHEST
Page 38 and 39: Synchronized Cardioversion WARNINGS
Page 40 and 41: � A “SYNC XXX J SEL” message
Page 42 and 43: After 6-l 0 seconds of charging to
Page 44 and 45: PACING PROCEDURE Noninvasive Tempor
Page 46 and 47: Increase pacer output mA until stim
Page 48 and 49: PACER LEAD FAULT The message “PAC
Page 50 and 51: PREPARATIONS Proper application and
Page 52 and 53: 1. Push ALARM SET button. Low alarm
Page 54 and 55: General Maintenence Resuscitation e
Page 56 and 57: SEll-ING TIME AND DATE Check the ti
Page 58 and 59: NOTE BATTERY CARE THE BATTERY A med
Page 60 and 61: � Noisy ECG display when using pa
Page 62 and 63: WARNING � � � . Chapter 9 NON
Page 64 and 65: ChaDter 9 An “STATUS XX” messag

Zoll 1400 Operators Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?