Zoll 1400 Operators Manual

PACING
PROCEDURE
Noninvasive Temporary Pacing
WARNINGS Before proceeding, CAREFULLY read the following:
Noninvasive pacing can be accomplished using either standard NTP 2000
pacing electrodes or PD 2200 Multi-function electrodes. Anatomical placement
and operation is identical.
To pace with NTP 2000 pacing electrodes, the paddles must be
pluged into
the unit. The pacing connector is part of the paddles cable assembly. PD
2200 Multi-function electrodes will not operate with the paddles installed.
To pace with PD 2200 Multi-function electrodes, the multi-function cable
must be pluged into the unit. NTP 2000 electrodes will not operate with the
multi-function cable installed.
Both pacing electrodes should be attached to the patient before connecting
the output cable.
Avoid touching the gelled area of the electrode while pacing. A minor electrical
shock hazard exists.
Multi-function electrodes should be used no longer than eight (8) hours for
continuous pacing.
The ZOLL PD1400 and NTP 2000 electrodes or PD-2200 multi-function electrodes
are intended for use as a system. Do not connect any other device to
the output connector.
SELECT MONITOR ON
SET OUTPUT TO
OmA