Red Giant Grain Stir-Ator - David Manufacturing Co.

STEP 10
Place the outboard pivot end over main
frame with track drive rollers’ toward the
outside. Secure with two 3/8" x 1" hexhead
bolts. Place flat washers on bolt,
putting bolt through outboard pivot end
and frame, securing with lock-washer
and nut on the inside (two on each side)
then place two 3/8" x 1" hex-head bolts
for four-auger machine (Two 3/8" x 2"
for six-auger machine) up through the
bottom of the frame, through the yoke
and secure with flat washer, lock-washer
and nut (Two on each side). See Photo
4 and Drawing D on page 42.
STEP 11
Thread main power cord and gearmotor
power cord (14-3) from the inboard pivot
through the loops on the side of the main
frame, with the main power cord only
ending where the large loops stop. The
gearmotor cord continues to the
opposite end of the main frame as shown
in Photo 5.
Photo 4
Greenfield shown in photo has been
replaced with 14-3 rubber covered wire.
Photo 5
16 PNEG-1358 Red Giant Stir-Ator