Red Giant Grain Stir-Ator - David Manufacturing Co.

More documents

Recommendations

Info

STEP 27 Place all belt shields as shown in Photo 28 (FOUR AUGER) - Photo 29 (SIX AUGER) - Photo 30 (OUTER SHIELD - SIX AUGER) -Photo 31 (FOUR & SIX AUGER TRACK DRIVE UNIT SHIELD). If electric motors other than the ones provided by David Manufacturing Co. are used, modification of the motor belt shield may become necessary. Photo 28 CUT SHIELDS TO FIT. DO NOT OPERATE WITHOUT SHIELDS BEING IN PLACE. Photo 29 DID YOU PUT #90 OIL IN THE GEAR BOXES Photo 30 Photo 31 28 PNEG-1358 Red Giant Stir-Ator
STEP 28 Assemble the two-piece suspension ‘T’, using a 3/8" x 2-1/2" hex-head bolt, and 3/8" hex locknut. See Photo 32 or Drawing B on page 38. STEP 28A Install link from center suspension tee into clevis. Install 1/2" x 2" bolt and securely tighten 1/2" lock nut. Take heavy electrical wire coming from center pivot junction box and pass through the “S” hook welded on top of suspension tee. Next, hook shutoff chain on to the same “S” hook. See Photo 32 or Drawings B, E, L, and M on pages 38, 44, 56 and 57, respectively. STEP 29 Raise unit into position with lift hooks as shown in Drawing L on page 56. If installing the Red Giant Stir-Ator into a new bin, to allow for some roof settling, hang the Red Giant 1 to 1-1/2 inches higher at the center. Phot 32 STEP 30 Be sure center suspension tee is as near level as possible and is at a ninety degree angle to the switch box so the automatic shut-off chain operates properly. It is necessary that the suspension tee be positioned with “S” hook being placed to the right, when viewed from the switch box. See picture of the bin in the Table of Contents or Photo 1 and Photo 32. STEP 31 Check to be sure the shut-off hook end of the suspension tube is located 90° to the switch box. If not, reposition the suspension chain hooks around the center fill hole. Attach the link end of the shut-off chain to the “S” hook which is welded on to the suspension tube. See Photo 1. Hook the other end to the “S” hook on the switch box handle. Rehook the excess chain with “S” hook attached PNEG-1358 Red Giant Stir-Ator 29
Page 1: OWNER’S MANUAL Red Giant Grain St
Page 4 and 5: SAFETY GUIDELINES This manual conta
Page 6 and 7: PRACTICE SAFE MAINTENANCE Always di
Page 8 and 9: FINAL INSPECTION CHECK LIST 1. HAVE
Page 10 and 11: PLEASE NOTE: THE DECALS SHOWN ON TH
Page 12 and 13: PLEASE NOTE: THE DECALS SHOWN ON TH
Page 14 and 15: STEP 3 NOTE THE SEVEN-INCH DISTANCE
Page 16 and 17: STEP 10 Place the outboard pivot en
Page 18 and 19: STEP 13 Place the 3/4" x 14" axle s
Page 20 and 21: STEP 17 Bolt the drive guide arm on
Page 22 and 23: STEP 21 Installation of gearbox dri
Page 24 and 25: STEP 22 Installation of gearbox con
Page 26 and 27: Accelerometer lead wire Power-out w
Page 30 and 31: to the shut-off chain so that it wi
Page 32 and 33: The augers are manufactured to allo
Page 34 and 35: NOTES 34 PNEG-1358 Red Giant Stir-A
Page 36 and 37: Red Giant Stir-Ator Overall Dimensi
Page 38 and 39: 4 - 6 Auger Shields and Electrical
Page 40 and 41: 4 - 6 Auger Trolley Base Unit Model
Page 42 and 43: Outboard Pivot End and Track Sectio
Page 44 and 45: Center Inboard Pivot End Model 176
Page 46 and 47: 6-AUGER TROLLEY EXTENSION DRAWING F
Page 48 and 49: RED GIANT WIRING DIAGRAMS Single Ph
Page 50 and 51: Three Phase - 460 Volt 50 PNEG-1358
Page 52 and 53: Three Phase - 380 Volt 52 PNEG-1358
Page 54 and 55: RED GIANT 460 VOLT TRANSFORMER HOOK
Page 56 and 57: DRAWING K DRAWING L 56 PNEG-1358 Re
Page 58 and 59: PINION SHAFTS DMC # Model # Year Fi
Page 60 and 61: GEARBOX #129 (104B2134) 104B2134 #1
Page 62 and 63: GEARBOX #150 (104B2135) 104B2135 #1
Page 64 and 65: RED GIANT TRACK DRIVE GEAR MOTOR GE
Page 66 and 67: DRYING RECOMMENDATIONS To get unifo
Page 68 and 69: STIR-GUARD OPERATION The Stir-Guard
Page 70 and 71: MAINTENANCE and ADJUSTMENTS (cont
Page 72 and 73: RED GIANT TROUBLE SHOOTING ELECTRIC
Page 74 and 75: RED GIANT TROUBLE SHOOTING TRACK UN
Page 76 and 77: NOTES 76 PNEG-1358 Red Giant Stir-A
Page 78:
Red Giant Grain Stir-Ator Model 176
show all

Red Giant Grain Stir-Ator - David Manufacturing Co.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?