Red Giant Grain Stir-Ator - David Manufacturing Co.

STEP 13
Place the 3/4" x 14" axle shaft through
the trolley body axle bushings. Two axles
are used on a four-auger trolley, and
three axles are used on all 36' four
auger, and all six-auger trolleys. After the
axles have been installed, place one
3/4" S.A.E. washer, the poly-wheel and
another 3/4" S.A.E. washer on each
side. Secure with a 3/16" x 1-1/4" cotter
pin. See Photo 8 and Drawing C on
page 40.
STEP 14
Place trolley on to the main frame.
Photo 8
Trolleys are marked ‘CENTER OF
BIN’. Be sure trolley is upon main
frame with the decal on the proper
end. Be sure poly-wheels are
setting properly on the rim of the
frame. See Photo 9.
Photo 9
18 PNEG-1358 Red Giant Stir-Ator