Red Giant Grain Stir-Ator - David Manufacturing Co.
Red Giant Grain Stir-Ator - David Manufacturing Co.
Red Giant Grain Stir-Ator - David Manufacturing Co.
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
STEP 22<br />
Installation of gearbox connecting-shaft<br />
shields using two shields for four-auger<br />
unit and three shields for six-auger unit.<br />
Simply place shield in position as shown<br />
in Photo 22. Firmly place notched end<br />
of shield between gearbox mounting<br />
brackets, and complete installation by<br />
hooking spring to the bottom side of the<br />
trolley frame. See Photo 22 and<br />
Drawing B on page 38.<br />
Greenfield shown in photo has been replaced<br />
with 14-3 rubber covered wire.<br />
PROPER INSTALLATION<br />
GREATLY REDUCES SERVICE<br />
CALLS<br />
Photo 22<br />
STEP 23<br />
Installation of trolley drive-arm assembly,<br />
which consists of three pieces: See<br />
Drawings C or F, pages 40 and 46. Attach<br />
to the trolley as shown in Photo 23<br />
using two 5/16" x 1" hex-head bolts with<br />
lock-washers and nuts. Attach opposite<br />
end of drive-arm to chain-connecting<br />
angle, using one 5/8" S.A.E. washer, and<br />
one 5/32" x 1" cotter pin. See Photo 24<br />
and Drawing E on page 44.<br />
Photo 23<br />
Photo 24<br />
24 PNEG-1358 <strong>Red</strong> <strong>Giant</strong> <strong>Stir</strong>-<strong>Ator</strong>
Change language