Red Giant Grain Stir-Ator - David Manufacturing Co.

FINAL INSPECTION CHECK LIST
1. HAVE YOU READ THE OWNER’S MANUAL COMPLETELY - YOURSELF STUDY IT.
2. Is there at least 7" clearance between the top of the track and the lowest part of the roof or roof
braces
3. Are the track splices correctly installed Consult the Drawings in the OWNER’S MANUAL
4. Is the suspension tee properly hung, LEVEL, with the end loops down, with lead-in wire and
shut-off chain properly installed
5. Is the frame of the Stirator about 1" higher at the center of the bin for NEW BIN INSTALLATION,
and LEVEL WITH EXISTING BINS
6. Are augers 3" off the drying floor at the bin wall
7. Were the augers notched with a file (NOT A TORCH) where the clamp bolts serve as a driving
key
8. Did you note the instructions NOT to weld flighting at the top end of the auger
9. Are you keeping a record of the serial number of each owner
10. If your Red Giant Stir-ator is equipped with three phase power, BE SURE YOUR ELECTRICIAN
HAS INSTALLED ADEQUATE MOTOR PROTECTION, (either magnetic or manual starters
can be used) or you will void the warranty on your three-phase motors.
11. Did you make sure that the owner received his owner’s manual, and was instructed that reading
and understanding the manual will help immensely
12. If electric motors other than the ones provided by David Manufacturing Company are used,
modification of the motor belt shield may become necessary. Cut to fit. Do not operate without
the shields being in place.
13. Did you put safety decals on bin; inside walk-in door; under side of man-hole cover
14. NOTE: Operating the Stir-Ator during bin unloading can be beneficial, and can prevent auger
damage. When the grain no longer flows into the center sump, the Stir-Ator should be shut off
to prevent auger damage.
15. NOTE: BURYING UNIT WILL DAMAGE BIN AND WILL VOID YOUR RED GIANT WARRANTY.
DID YOU PUT #90 OIL IN THE GEAR BOXES
PROPER INSTALLATION GREATLY REDUCES SERVICE CALLS
8 PNEG-1358 Red Giant Stir-Ator