Red Giant Grain Stir-Ator - David Manufacturing Co.

to the shut-off chain so that it will not get
caught on the unit. See Photo AA. Use
the shut-off support chain(s) to hold the
shut-off chain so that there is adequate
clearance between the shut-off chain and
the Red Giant as it travels underneath. See
drawings A and B on pages 35 and 38.
Remove the wire support “S” hook which
is banded to the hook attached to the chain
end with a plastic tie strap. Loop the
support chain under shut-off chain lifting it
for clearance and hook to main strand.
See Photo BB.
After all adjusting has been completed, “S”
hooks on suspension chains and shut-off
chains should be closed. Hook wire
support “S” hook to support chain -
approximately 12" above shut-off chain.
See Photo BB.
String the lead-in wire through the chain
link clevis on the bottom of the suspension
bar toward the end of the bar with the
safety chain “S” hook. (DO NOT ATTACH
THE WIRE TO THE END OF THE
SUSPENSION BAR). The lead-in wire can
then be suspended above the safety chain
and routed to the switch box as shown in
the owner’s manual. See Photos 32 and
BB.
Photo AA
Photo BB
The lead-in wire from Red Giant to
the switch box must be longer and
looser than the shut-off chain itself.
Should the Red Giant malfunction
and engage the shut-off, this prevents
the lead-in wire from being torn from
the switch box which could result in
serious electrical shock.
Operating the Red Giant Stir-Ator
without shut-off chain properly
assembled and installed could
result in SERIOUS ELECTRICAL
SHOCK or BODILY INJURY and
WOULD VOID THE WARRANTY.
30 PNEG-1358 Red Giant Stir-Ator