Technisches Manual EMP 900

Technical Manual EMP 8x0.00/04/13/14 v6
wh Münzprüfer Berlin GmbH, Germany
2.1.1. Technical Overview EMP 8x0.00 v6, 8x0.04 v6 und 8x0.13
v6
coin acceptance
coin blocking
output signals
output pulse length
coin return
supply voltage
supply current
32 coin channels, 16 master and 16 slave channels
Complete blocking via the machine controller. In addition,
any individual coin, or group of coins can also be blocked
through DIP switches.
Individual coin blocking via coin output lines (Option /O)
Six open collector output lines are available. Each output line
can be freely assigned to any of the 16 master coin channels
through programming.
45 Volt / 500 mA
1ms to 65 seconds, programmable
The coin selector gives an active LOW signal on the coin
reject line when the coin return button is pressed.
10 V to 26 volts DC
< 30 mA in standby, during coin acceptance briefly 300 mA.
No power is needed for battery operated coin selectors in
standby
temperature range +10°C to +70 °C
humidity classification according to DIN 40040: F
coin sizes
max. diameter x max. thickness: 32.5 x3.4 mm
dimensions
height x width x depth: 104 x 53 x 93.5 mm (without front
plate)
Options
/A power supply connections are reversed, 7 coin output lines,
no coin reject signal
/B battery operation (standard)
/C battery operation with inductive sensor
/E extended temperature and humidity range
–20°C to +70°C, humidity classification E/D:
/F large coin funnel
/I inventory impulse
/N coin output signals inverted
/O individual coin blocking via parallel lines
/P no coin reject signal
/R additional light barrier to observe coin return path
/S preceding coin output signal
/T teach mode (2 coin channels activated)
/X control for external sorting flaps
/Z additional external strimming detection
version 1.40
page 10/53 subject to technical modification EMP8x0.00/04/13/14 v6