25.06.2015 Views

Administering Platform LSF - SAS

Administering Platform LSF - SAS

Administering Platform LSF - SAS

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Chapter 42<br />

Troubleshooting and Error Messages<br />

initLicense: Trying to get license for LIM from source<br />

<br />

getLicense: Can’t get software license for LIM from license file<br />

: feature not yet available.<br />

Your <strong>LSF</strong> license is not yet valid. Check whether the system clock is correct.<br />

findHostbyAddr/: Host / is unknown by <br />

function: Gethostbyaddr_(/) failed: error<br />

main: Request from unknown host /: error<br />

function: Received request from non-<strong>LSF</strong> host /<br />

The daemon does not recognize host. The request is not serviced. These<br />

messages can occur if host was added to the configuration files, but not all the<br />

daemons have been reconfigured to read the new information. If the problem<br />

still occurs after reconfiguring all the daemons, check whether the host is a<br />

multi-addressed host.<br />

See “Host Naming” on page 88 for information about working with multiaddressed<br />

hosts.<br />

rcvLoadVector: Sender (/) may have different config?<br />

MasterRegister: Sender (host) may have different config?<br />

LIM detected inconsistent configuration information with the sending LIM. Run<br />

the following command so that all the LIMs have the same configuration<br />

information.<br />

% lsadmin reconfig<br />

Note any hosts that failed to be contacted.<br />

rcvLoadVector: Got load from client-only host /. Kill LIM on<br />

/<br />

A LIM is running on a client host. Run the following command, or go to the<br />

client host and kill the LIM daemon.<br />

% lsadmin limshutdown host<br />

saveIndx: Unknown index name from ELIM<br />

LIM received an external load index name that is not defined in the<br />

lsf.shared file. If name is defined in lsf.shared, reconfigure the LIM.<br />

Otherwise, add name to the lsf.shared file and reconfigure all the LIMs.<br />

saveIndx: ELIM over-riding value of index <br />

This is a warning message. The ELIM sent a value for one of the built-in index<br />

names. LIM uses the value from ELIM in place of the value obtained from the<br />

kernel.<br />

getusr: Protocol error numIndx not read (cc=num): error<br />

getusr: Protocol error on index number (cc=num): error<br />

Protocol error between ELIM and LIM.<br />

<strong>Administering</strong> <strong>Platform</strong> <strong>LSF</strong> 537

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!