DVS GSR Insert Owner's Manual - Travis Industries Dealer Services ...
DVS GSR Insert Owner's Manual - Travis Industries Dealer Services ...
DVS GSR Insert Owner's Manual - Travis Industries Dealer Services ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
8 Installation (for qualified installers only)<br />
Top Convection Deflector<br />
Install the top convection deflector as<br />
shown to the right.<br />
The deflector is shipped on top of the<br />
insert. The screws are shipped inside<br />
the owner's pack.<br />
Fireplace Requirements<br />
<br />
<br />
<br />
<strong>Insert</strong> must be placed within a code-conforming masonry fireplace or tested and listed factory-built<br />
(metal) wood-burning fireplace. Repair any fireplace damage prior to installation.<br />
Because the insert uses a circulation blower, clean the fireplace, smoke shelf, and chimney prior to<br />
installation.<br />
This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance<br />
produces when determining a location.<br />
a<br />
f<br />
b<br />
Fireplace Sizing 3-Piece Panel 1-Piece Panel<br />
a Minimum Height 19-1/2” (496mm) 20-5/8” (524mm)<br />
b Minimum Width 26-1/2” (674mm) 29” (737mm)<br />
c Minimum Depth 15-1/8” (385mm) 16-3/8” (416mm)<br />
d Hearth Extension 1-1/4” (32mm) 0” (0mm)<br />
e<br />
c<br />
g<br />
h<br />
e<br />
f<br />
The gas and electrical line should be installed prior to<br />
installing the heater.<br />
For tight fits (under 24”) see the section “Removing the<br />
Vent Connector”<br />
d<br />
g See “Leveling Bolts” for details on leveling the heater.<br />
h Attach the “This fireplace has been altered…” plate to the fireplace (use two screws or other<br />
suitable method). You may wish to place it in a location where it will be covered by the surround panels.<br />
© <strong>Travis</strong> <strong>Industries</strong> 4090812 100-01232_001