TeSys protection components - Trinet

Schemes
Installation system
Tego Power for motor power-starter components
Control-command circuit diagrams for a direct starter
(conforming to standards "Low voltage installation regulations" C 15-100 and "Machine safety" NF EN 60205-1 standards)
1 - Without APP-1DppppD connection blocks and with frontal auxiliary contact 2 - With APP-1DppppD connection blocks and frontal auxiliary contact
GV2-AE20
GV2-AE20
3 - With forced local start, cable on shunt (3) - (without APP-1ppppD connection
blocks and with frontal auxiliary contact GV2-AE20). The cabling of the shunt for
a forced local start is equally possible with connection blocks APP-1ppppD
A Tego Power sub-base
B Communication module
X1, X4 HE 10 connector, removable terminal block (see below)
Q1 Thermal-magnetic motor circuit-breaker
(1) Km1 : APP-1ER or APP-1ES interface relay
(2) KM1 : contactor coil
(3) External shunt on the lower connection block. It can be used to connect an external input.
(4) To communication module
(5) Maximum control voltage of contactor coils c 48 V/a 240 V
(6) Control unit (option) for forced local start
(7) 2-position “Auto-Manual” selector switch (option)
APP-1CE and APP-1CV communication modules
24 V power supply :
V In : inputs
V Out : outputs
A
B
X1
X2
X3
X4
Tego Power sub-base
Communication module
Removable terminal block for connection of circuit-breaker contacts 1 to 8 (terminals QI.1 to QI.8)
Removable terminal block for connection of contactor contacts 1 to 8 (terminals KMI.1 to KMI.8)
Removable terminal block for connection of interface relays 1 to 8 (terminals KmO.1 to KmO.8)
Removable terminal block for the I/O 24 V supply
Presentation, description :
pages 15010/2 and 15010/3
Selection :
pages 15011/2 and 15011/3
Characteristics :
pages 15013/2 to 15013/5
References :
pages 15014/2 and 15014/3
5016 Ver4.00-EN.fm/2 Schneider Electric