Carbon Cortex-A9 Model User Guide for SoC Designer

Setting Component Parameters 1-11Table 1-3 Component Parameters (Continued)NameDescriptionAllowedValuesDefault Value Runtime 1TEINITVINITHIDefault exception handling state:0 = ARM1 = ThumbIndividual processor control of thelocation of the exception vectors atreset.0 — 0xF forMPCore0, 1 forUNICore0 — 0xF forMPCore0,1 for UNICore0 NoWaveform File 3 Name of the waveform file. string carbon_CORTEX NoA9.vcd orcarbon_CORTEXA9MP.vcdWaveform Format Format of the waveform dump file. VCD, FSDB VCD NoWaveform Timescale Sets the timescale to be used in thewaveform.Many values indrop-down1 ns No1. Yes means the parameter can be dynamically changed during simulation, No means it can be changed onlywhen building the system, Reset means it can be changed during simulation, but its new value will be takeninto account only at the next reset.2. Carbon recommends using the Memory Map Editor (MME) in SoC Designer Plus, which provides centralizedviewing and management of the memory regions available to the components in a system. For informationabout migrating existing systems to use the MME, refer to Chapter 9 of the SoC Designer Plus User Guide.3. When enabled, SoC Designer Plus writes accumulated waveforms to the waveform file in the following situations:when the waveform buffer fills, when validation is paused and when validation finishes, and at the end ofeach validation run.0x0NoCarbon Design Systems, Inc. Confidential