MM850402-06 Gas Analysers 3000-4000 - om.gr

Instruction Manual MM850402 ed. 06• Press the [ANALYSIS] (F1) key to start the measurements. The following page will appear:O2 20.9 %CO2 0.1 %CO1 ppmTg Tc ErrorEffN --------EffG --------REF. O2GRAPHIC–Pressing the [] and [] keys, it is possible to zoom-in and zoom-out increasing or decreasing the number ofdisplayed parameters.O2 20.9%CO2 0.1%CO 37ppmREF O2GRAPHIC–O2 20.9% Ta 28.1CCO2 0.1% ∆t Calc ECO 38p Los------NO 0p λ ------Tg TC Err Eff------Eff-------REF O2GRAPHIC–Pressing the [] and [] you can change page for others parameters.Pressing the [REF. O 2 ] key the measured parameters will be referred to the user-defined programmed oxygenvalue. When operator select this mode, the symbol “O2” will be displayed on the status bar.O2 20.9%CO2 0.1%CO -------%O2 3.0 GRAPHICO2–If the graphical option (Table E=4 on ordering code) is installed, the instrument can display the measured valuesas bar-graph. Press the [GRAPHIC] (F2) key to change mode.O2∆T Err CalcRen? -----------------CONOREF. O2NUMERIC–Using GasConfig Software, you can program the graph page: Assign up to 6 different parameter, range andincrement direction. See chapter 9 for software instructions.Press the [NUMERIC] (F2) key to return to the normal display mode.7.3 Pressure/Draugh measurementIf the internal pressure sensor is installed (Table E=2 on ordering code), you can execute the pressure/Draftmeasurements using the standard probe or the special probe.31