MM850402-06 Gas Analysers 3000-4000 - om.gr

Instruction Manual MM850402 ed. 069 CONFIGURATIONMany parameters can be modified using the instrument keyboard. Pressing the [SETUP] key, you can change thecurrent fuel, include or exclude the CO cell, change the technical unit, set the alarms, etc. TheCONFIGURATION P1--- FUEL ---> LPGCO SENS. Includ.FUEL PARAMETERSNEXTESCAPE–• press [NEXT] to change menu pageCONFIGURATIONPAG2ENGENEER UNITSALARMSO2 REFERENCESNEXTESCAPE–• Use the [] and [] keys to move the cursor symbol to the desired option.• Press the [ENTER] key to select the option.• Press [ESCAPE] (F1) to return to the previous menu.FuelYou can select between the pre-set fuel table (LPG, Diesel oil, Oil, Natural gas) or, ifprogrammed using the configuration PC software.CO CellIf the CO electro-valve option is installed, you can Include, exclude or automaticallyselect (using the PC configuration software, you can program the CO level forautomatic exclusion) the CO cell.Fuel Parameters You can display only the constant table for the selected fuel. To change the values,you should use the configuration PC software.Engineering Unit You can change the technical units for gas, temperature and pressuremeasurements.Alarms You can set the alarms levels, Min/Max operation and enable/disable all the 4possible acoustic and visible alarms.O2 ReferencesYou can set the %O2 for CO measurements and %O2 for other gas.9.1 Engineering UnitsWhen you select the Engineering units option, the following page will be displayed:ENGINEER UNITS> CO ppmOther ppmTemp. °CPress. hPaESCAPE–• Use the [] and [] keys to move the cursor symbol to the desired option.• Press the [ENTER] key to change the value.• Press [ESCAPE] (F1) to return to the previous menu.The measuring units selectable for gas are: ppm, mg/m3, mg/kWh, g/GJ.The measuring units selectable for temperature are: °C, °F.The measuring units selectable for pressure are: hPa, mbar, mmH2O, inH2O.52