10 table saw - Grizzly Industrial Inc.

3. Attach the short upper and lower side bracesto one of the assembled side panels. Use theM8 - 1.25 x 16 carriage bolts, 8MM flat washersand M8-1.25 hex nuts as shown inFigure 9.6. Note the location of the mounting holes onthe top of the stand. Turn the table saw bodyupside-down and place the dust hood andadapter assembly over the bottom of thetable saw body with the dust port flangepointed up.All Models:7. Align the holes at the four corners. Place theassembled stand upside down on the tablesaw body, and line up its mounting holes.Make certain the side of the stand with the “ZSeries” label, if applicable, is on the front sideof the machine (the side with the Grizzly labeland angle scale). Secure with M8-1.25 x 19hex bolts, 8MM flat washers and M8-1.25hex nuts, with the dust port sandwichedbetween as shown in Figure 11.Figure 9. Assembled stand section.4. Bolt the other side panel to the upper andlower braces using the M8-1.25 x 16 carriagebolts, 8MM flat washers and M8-1.25hex nuts as shown in Figure 10.Saw BodyDust HoodAdapterDust HoodStandFigure 11. Attaching the stand to the saw base.Figure 10. Stand completely assembled.8. With the help of a second person, flip theentire table saw unit right side-up and moveit into its working position. Level the stand bychecking all sides for symmetry. Measurediagonally from top to bottom and adjust thestand so both diagonals are equal. Tightenall of the stand bolts.G1022ZF and ZFX:5. Take the black plastic dust hood with the 4"port and align it with the opening in theadapter. The bolt holes on each of the fourcorners should line up. Using 10-24 x 3 ⁄8"bolts, 10-24 nuts and 3 ⁄16" lock washers tosecure the hood to the adapter.-18- G1022 Series Contractor Saws