10 table saw - Grizzly Industrial Inc.

Figure 28. Checking alignment of blade guard.7. If the blade guard/splitter is to the right of theblade as shown in Figure 29. simply addwashers between the splitter and frontmounting bracket, and adjust the rear splittersupport as shown in Figure 29.Figure 30. Proper splitter/blade alignment.8. Recheck guard alignment to the blade and tothe table top. Adjust as necessary and tightenall the bolts before use. If the blade guardis properly aligned, please skip ahead to thenext section; otherwise, continue with thenext step.9. If the splitter is positioned to the left of theblade, alignment cannot be achieved bywasher placement. Adjustment of the frontsupport bracket is required as shown inFigure 30. Loosen the adjustment screwsand move to the right.10. Recheck guard alignment to the blade and tothe table top. Adjust as necessary and tightendown all the bolts before use.Figure 29. Improper splitter/blade alignment.11. Adjust the blade to 45° and raise and lower itthrough the full range. Readjust blade to 90°and raise and lower it through the full range.There should be no contact between thebase and the table insert or any other part ofthe saw. If there is, repeat Steps 1-10.G1022 Series Contractor Saws -25-