C11T- MULTIFUNCTION CNC BOARD Rev. 2 - CNC4PC

More documents

Recommendations

Info

C32 (Rev. 1.1) User Manualhave to set the speed of the motor (spindle) at maximum. For acceleration valuesadjust them to where you feel comfortable. Keep in mind the acceleration of themotor must also be set in your VFD.For configuring Mach follow these steps:1. Go to Config / Ports&Pins / Motor Outputs. Enable the spindle and select the portand pins you wired for step and direction.Fig. 4. Ports&Pins configuration screenshot2. Go to Config / Ports&Pins / Spindle Setup. In the motor control box, check UseSpindle Motor Output and Step /Dir Motor. Under Pulley Ratios set the pulleyratios of the machine.Revision: 9/14/2010 http://cnc4pc.com/TechDocs/C32R1_1_User_Manual.pdf 10/20
C32 (Rev. 1.1) User ManualFig. 5. Spindle Setup screenshot.3. Go to Config / Motor Tuning / Spindle. On Steps per unit put 1,000, set velocity tomaximum. For Acceleration, choose the acceleration that you feel comfortablewith. Start slow, increase acceleration as you test your system. Under Step Pulselength, use a number from 3 to 5, but start with 3. This number is directlyproportional to the final voltage you will get in the analog output. Use this numberand the fine tuning pot to adjust the voltage you want to get at max speed.Fig. 6. Motor Tuning and Setup screenshot.After configuring the Mach, these steps should be followed.Step 1. Ensure that all external power sources are set to OFF.Step 2. Connect the power supply to the Power Inputs Connectors (X1).Step 3. Turn on the external suppliesStep 4. Connect a multimeter in the analog outputs connectors (X2) and make andfine tune this output:Revision: 9/14/2010 http://cnc4pc.com/TechDocs/C32R1_1_User_Manual.pdf 11/20
Page 1 and 2: C11T (Rev.2.1) User ManualC11T- MUL
Page 3 and 4: C11T (Rev.2.1) User ManualGeckodriv
Page 5 and 6: C11T (Rev.2.1) User Manual4. Functi
Page 7 and 8: C11T (Rev.2.1) User Manual5. Specia
Page 9: C32 (Rev. 1.1) User Manual5.2 Varia
Page 13 and 14: C32 (Rev. 1.1) User Manual Enables
Page 15 and 16: C11T (Rev. 2.1) User ManualWhen the
Page 17 and 18: C11T (Rev. 2.1) User ManualFig. 11
Page 19 and 20: C11T (Rev. 2.1) User ManualFig. 16
Page 21 and 22: C11T (Rev. 2.1) User ManualPOSSIBLE
Page 23: C11T (Rev. 2.1) User Manual8. Dimen

C11T- MULTIFUNCTION CNC BOARD Rev. 2 - CNC4PC

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?