C11T- MULTIFUNCTION CNC BOARD Rev. 2 - CNC4PC

More documents

Recommendations

Info

C11T (Rev. 2.1) User ManualIf at any time after that a condition occurs that causes the GECKO SERVO DRIVEto “fault out”, such as not being able to complete a step command, the ERR/RESterminal will be activated, signaling the microcontroller an error has occurred. Inthis case the Standby LED indicator and the driver error LED indicator will lightup to indicate that an error has occurred in a driver.If the E-STOP button is pressed the Standby LED indicator and the E-STOP errorLED indicator will light up.If the SCHP detection function is activated, and the system is ready (STANDBYLED OFF), and an error has occurred with the SCHP signal, the Standby LEDindicator and the SCHP error LED indicator will light up.6. Wiring diagramsWhile this board supports only TTL +5VDC signals, different kind of sensors,switches using different voltages can be connected using the diagrams that follow:Note: The below wiring diagrams are an example, any input can be used for the connections.Fig. 10 Wiring diagram to connect switches.Revision: 9/23/2010 http://cnc4pc.com/TechDocs/C11TR2_1_User_Manual.pdf 16/24
C11T (Rev. 2.1) User ManualFig. 11 Wiring diagram to connect NPN open collector proximity sensors.For a 24V or 12V sensor, the recommended value for the external resistor R1 is4.7K Ohm.Fig. 12 Wiring diagram to connect in parallel NPN open collector proximity sensors.Note: External Supply GND should be connected to the C11T GND inputs terminalRevision: 9/23/2010 http://cnc4pc.com/TechDocs/C11TR2_1_User_Manual.pdf 17/24
Page 1 and 2: C11T (Rev.2.1) User ManualC11T- MUL
Page 3 and 4: C11T (Rev.2.1) User ManualGeckodriv
Page 5 and 6: C11T (Rev.2.1) User Manual4. Functi
Page 7 and 8: C11T (Rev.2.1) User Manual5. Specia
Page 9 and 10: C32 (Rev. 1.1) User Manual5.2 Varia
Page 11 and 12: C32 (Rev. 1.1) User ManualFig. 5. S
Page 13 and 14: C32 (Rev. 1.1) User Manual Enables
Page 15: C11T (Rev. 2.1) User ManualWhen the
Page 19 and 20: C11T (Rev. 2.1) User ManualFig. 16
Page 21 and 22: C11T (Rev. 2.1) User ManualPOSSIBLE
Page 23: C11T (Rev. 2.1) User Manual8. Dimen

C11T- MULTIFUNCTION CNC BOARD Rev. 2 - CNC4PC

Create successful ePaper yourself

Delete template?

Save as template?