C11T- MULTIFUNCTION CNC BOARD Rev. 2 - CNC4PC

More documents

Recommendations

Info

C11T (Rev. 2.1) User Manualparallel cable or parallel port.port.SYMPTOM 5: THE ANALOG OUTPUT DOES NOT REACH THE 10VDC.POSSIBLE CAUSEPOSSIBLE SOLUTIONS- Insufficient pulse width. It is possiblethat the signal pulse width is notenough to activate the optocouplers.- The signal is set active low or thebreakout board could be invertingthe signals.- In Mach X, go to Config / Motor Tuning /Spindle. Under Step Pulse lengthincrease this value, use a number from 3to 5, but start with 3.- In Mach X, go to Config / Ports&Pins /Motor Outputs. Change the active lowstatus of the pin used for step.Revision: 9/23/2010 http://cnc4pc.com/TechDocs/C11TR2_1_User_Manual.pdf 22/24
C11T (Rev. 2.1) User Manual8. Dimensions.All dimensions are in Millimeters.Disclaimer:Use caution. CNC machines can be dangerous machines. Neither DUNCAN USA, LLC norArturo Duncan are liable for any accidents resulting from the improper use of thesedevices. The M43 is not a fail-safe device and it should not be used in life support systemsor in other devices where its failure or possible erratic operation could cause propertydamage, bodily injury or loss of life.Revision: 9/23/2010 http://cnc4pc.com/TechDocs/C11TR2_1_User_Manual.pdf 23/24
Page 1 and 2: C11T (Rev.2.1) User ManualC11T- MUL
Page 3 and 4: C11T (Rev.2.1) User ManualGeckodriv
Page 5 and 6: C11T (Rev.2.1) User Manual4. Functi
Page 7 and 8: C11T (Rev.2.1) User Manual5. Specia
Page 9 and 10: C32 (Rev. 1.1) User Manual5.2 Varia
Page 11 and 12: C32 (Rev. 1.1) User ManualFig. 5. S
Page 13 and 14: C32 (Rev. 1.1) User Manual Enables
Page 15 and 16: C11T (Rev. 2.1) User ManualWhen the
Page 17 and 18: C11T (Rev. 2.1) User ManualFig. 11
Page 19 and 20: C11T (Rev. 2.1) User ManualFig. 16
Page 21: C11T (Rev. 2.1) User ManualPOSSIBLE

C11T- MULTIFUNCTION CNC BOARD Rev. 2 - CNC4PC

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?