User Manual DAP 26 - KME

More documents

Recommendations

Info

$H:\Marketing_Vertrieb\Bedienungsanleitungen ... - KME$

$H:\Marketing_Vertrieb\Bedienungsanleitungen ... - KME$

High-pass and Low-passTo restrict the frequency response of an acoustic system in the low or the high end,the high pass (which actually means “low-cut”) and the low pass filter is implemented.LPLowpass Filter 12 dB with adjustable “Q” factormid frequency 20 Hz - 44 kHzbandwidth „Q“ 0,1 - 20At Q= 0,7 you have a „normal“ low pass filter like you find it in some professionalmixing consoles (High-Cut).Setting the bandwidth outside of Q 2,0 is not recommended.HPHigh Pass Filter 12 dB with adjustable “Q” factormid frequency 20 Hz - 44 kHzbandwidth „Q“ 0,1 - 20At Q= 0,7 you have a „normal“ low pass filter like you find it in some professionalmixing consoles (Lo-Cut).Setting the bandwidth outside of Q 2,0 is not recommended.BPBandpass- Filter with adjustable “Q” factorThe band-pass filter is rarely used in professional audio technology. The band-passfilter lets, in opposite to the notch filter, pass a audio band defined by the midfrequency and bandwidth.
mid frequency 20 Hz - 44 kHzbandwidth „Q“ 0,1 - 20BSNotch FilterThe notch filter filters out a frequency range defined by the mid frequency and thebandwidth. With a “Q” factor above 5 this filter is very narrow, allowing the user tofilter out unwanted frequencies (i.e. mains hum at 50 Hz and certain harmonics)completely. With a “Q” factor below 5 the filter response is quite wide but this set-upis seldom used in professional audio systems.mid frequency 20 Hz - 44 kHzbandwidth „Q“ 0,1 - 20
Page 3 and 4: Functional unitsThe DAP 26 offers a
Page 5 and 6: There is a 10-digit LED bar-graph f
Page 10 and 11: This cable can be used connecting t
Page 12 and 13: HandlingFunctional units (digital)A
Page 14 and 15: Depending to the setting of the par
Page 16 and 17: PEQ IParametric Equalizer Type IFul
Page 20 and 21: All-pass filters do not change the
Page 22 and 23: Select an installation folder in yo
Page 24 and 25: Installation Problems:• Program c
Page 26 and 27: Example: Connecting two DAP 26 on d
Page 28 and 29: Select a file name for your preset
Page 30 and 31: Attention!If you forget the passwor
Page 32 and 33: About DAP 26The ‚About’ functio
Page 34 and 35: Selecting ‚Yes’ opens the ‚Sa
Page 36 and 37: Signal FlowThe register tabs can be
Page 38 and 39: In this window you can set the time
Page 40 and 41: Filters 1-4 are to be set to the va
Page 42 and 43: As you can see the output channel 1
Page 44 and 45: The ‚Dynamic’ Window displays t
Page 46 and 47: Attack TimeRelease TimeThis time-co
Page 48 and 49: Appendix - Technical DataTechnical
Page 52: Klingenthaler Musikelektronik GmbHA

User Manual DAP 26 - KME

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?