SA03-01 (X Series) Installation Manual.pdf - Footprint Security

Step 3 – Obtain current camera settings3Wait up to 30s until 1 greenblink per motion trigger2Turn on PowerswitchON1Remove the casebottomand InsertSD card4**Remove SD card**If the Xtern-Cam does not have a remote control unit and remotereceiver board, the power switch must be turned off to DISARM theCamera before removing the SD card!After removing the card from the camera it will contain a file with settings in it. Theformat of the contents of this file is critical to the camera operating correctly andshould only be changed using Camera Setup software.If the settings file has been modified via a third party editor and the camera does notfunction properly, delete settings.txt from the card and repeat step 5. A new filecontaining the current settings will be automatically generated by the camera.Step 4 – Set Camera Date and Time1Ensure memory card containscurrent camera settingsStep 3 - Obtain current camera settings2Insert card in reader3Start Camera Setupsoftware and select‘Configuration’ (Default)then click on ‘Continue’SA03-01 (X SERIES) INSTALLATION MANUAL V1.0.1 (APRIL 2009) 11