Operating instructions - TRW Automotive Aftermarket
Operating instructions - TRW Automotive Aftermarket
Operating instructions - TRW Automotive Aftermarket
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
FastCheck<br />
• Parking Brake Actuator - Removal/Installation<br />
The purpose is to allow the brake cables to be connected or disconnected to the<br />
brakes.<br />
Pre-Test conditions:<br />
• The vehicle must be stationary.<br />
• The ignition must be on (position II).<br />
• An approved battery charger must be connected to ensure consistent power<br />
supply.<br />
NOTE: To remove the parking brake from Mounting Position; switch the parking<br />
brake switch on and off twice.<br />
NOTE: When the vehicle is in the 'Mounting Position' a red flashing light will appear<br />
on the instrument cluster. This indicates that the parking brake actuator is in the<br />
'Mounting Position'. It does not indicate a vehicle fault.<br />
Ensure the on screen <strong>instructions</strong> on the service tool are followed precisely and in<br />
the correct order.<br />
Latching Position<br />
This procedure may be necessary if the Parking Brake emergency release has been<br />
activated, in order to re-latch the Parking brake.<br />
Pre-Test conditions:<br />
• The vehicle must be stationary.<br />
• The ignition must be on (position II).<br />
• An approved battery charger must be connected to ensure consistent power<br />
supply.<br />
Ensure the on screen <strong>instructions</strong> on the service tool are followed precisely and in<br />
the correct order.<br />
92