Operating instructions - TRW Automotive Aftermarket
Operating instructions - TRW Automotive Aftermarket
Operating instructions - TRW Automotive Aftermarket
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
FastCheck<br />
Longitudinal Accelerometer Calibration<br />
This procedure may be necessary if the Longitudinal Accelerometer has been<br />
replaced.<br />
Pre-Test conditions:<br />
• The ignition must be on (position II).<br />
• An approved battery charger must be connected to ensure consistent power<br />
supply.<br />
• Ensure the vehicle is placed on a level surface and that it remains stationary<br />
throughout the whole procedure.<br />
• Ensure the vehicle is stationary (0 km/h) on a level surface & no apply or release<br />
command has been received.<br />
• Make sure the parking brake module is correctly secured to the vehicle and that<br />
the parking brake is applied.<br />
Ensure the on screen <strong>instructions</strong> on the service tool are followed precisely and in<br />
the correct order.<br />
MANUAL FUNCTIONS<br />
The following can be performed manually without the scan tool:<br />
Disable Parking Brake for Rear Brake Disc Change<br />
This procedure is necessary before carrying out work on the rear brake discs. When<br />
performed correctly the brake callipers are wound back by the control module:<br />
Manual Routine:<br />
• Turn the ignition key to position II.<br />
• Apply, and hold, the footbrake,<br />
• Apply, and hold, the parking brake switch to the RELEASE position.<br />
• Turn the ignition key to position 0 and remove the key.<br />
• Release the footbrake.<br />
• Release the parking brake switch.<br />
• Remove fuse number 8 from the BJB (to isolate the parking brake electrical<br />
circuit).<br />
This will ensure safe working conditions and eradicate the threat of the parking<br />
brake accidentally coming on while the technician is working on it.<br />
To Re-enable Normal Operation:<br />
• Re-install fuse number 8 into the BJB (to re-enable the parking brake electrical<br />
circuit).<br />
93