Multisport 270 Owner's Manual - Aquaglide

B-16B-19Main Sheet/Uphaul StrapMain Sheet/Uphaul Strap16. Next, tie the Mainsheet/ Uphaul Strap to the back of the boom.Thread the white rope at the top portion of the Mainsheet Strap throughthe black rope loop at the back of the boom.C. Preparing the Sailing HarnessC-117. Take an additional turn around the black loop.FrontBridle StrapBackB-17Main Sheet/Uphaul StrapShroudConnection Points1. Next, prepare the sailing harness. The first step is to install the bridlestraps. Photo C1 shows one bridle strap completed on the left (port) sideof the hull. Steps C2 through C11 are taken during initial setup, however,for sailboat use, the bridle straps can be left on the hull indefinitely. Forwindsurf, tow or kayak use, the bridle straps should be removed.18 - 19. Tie the white rope to itself using a double half hitch or similarsecure, non-permanent knot, as shown in photos B18 & B19.B-182. Locate and remove the two bridle straps from the sailing harness asshown. The bridle straps have webbing and a clear tubing section.C-2Sailing HarnessBridle StrapsMain Sheet/Uphaul Strapfor more info go to:10Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966www.Aquaglide.net