Multisport 270 Owner's Manual - Aquaglide

V. Assembly - TowableB-3When towing the Multisport 270 behind a boat only the hull is used,consequently, there is very little assembly to be done. The followingsteps outline the steps to be taken and the points to note.FrontA. Preparing the Hull1. Same as the steps for preparing the hull in sailboat mode located onpage 6.B. Points to Note1. Remove the bridle straps from each side of the hull.B-1Mast StepZipper3. Remove the mast step from its zipper pocket on the top of the hull.This is done to protect users from being hurt by contact with the maststep during high-speed towing.4. DO NOT tow the Multisport 270 with attachments of any kind. Neveruse the sailing rig, keels or rudder during high-speed towing as damageand/ or injury may result.C. Attaching a Tow Rope1. Take the end of the tow rope through the tow fitting at the front of thehull as shown in photo C1. Note: tow rope not included.Tow Fitting2. Remove the forestay webbing strap from the tow fitting.B-2FrontTow Rope(not included)for more info go to:22Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966www.Aquaglide.net