Multisport 270 Owner's Manual - Aquaglide

B-6B-86. Open the clamp at the boom front end and remove the rope loopfrom the retainer hook as shown in photo B6.7. Extend the boom to its full length. The boom is set to the properlength when the spring pins are in the “USE” position as shown below.To lengthen, simultaneously press both spring pins and pull outward onthe tail of the boom until the pins snap into the USE position.8. Next, Slide the boom upward from the bottom of the sail, threading thesail through the space between the boom arms. The boom connects tothe mast through the lower cutout in the luff sleeve.9. With the boom clamp open, pry the grip section open enough toinsert the mast. The grip section is designed to flex enough toaccomodate the mast.B-7 B-910. Pass the rope loop around the back of the mast and over theretainer hook. Before closing the clamp, position the boom roughly inthe middle of the sail’s lower sleeve cutout. See photo B10 on followingpage.for more info go to:8Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966www.Aquaglide.net